This topic contains 4 replies, has 3 voices, and was last updated by 
alien_brain 9 years, 2 months ago.
-
Posts
-
Hello,
I installed the firmware and played the zaq for about a total of 6-8 hours (multiple sessions). After using the BCR a total of 10 times it will no longer turn on. Does anyone know how to reset it or know of a known issue that I could possibly look into?
Thanks for any help!!
Hi Eric,
sorry to hear that your BCR is acting up.
Have you tried turning it on in bootloader mode (hold Store+Load during powering on)?
This mode is independent of the firmware that´s installed and should always work as a fallback. If this mode still works you can try reinstalling the firmware and see if you can get it to run again.Thanks Christian,
I tried bootloader mode and it made the LEDs dimly rotate around the top knobs and the screen blink dimly as well. Does that sound correct or dead??
Hi Eric,
I´m afraid that doesn´t sound good.
In bootloader mode the BCR shoud simply say “LOAd” in the display.I would think you have the following options:
- get it repaired in a workshop
- buy a new BCR, in which case I could help you to transfer the license. If you want to go this way, please write me a short email to support@zaqaudio.com and I´ll go through the details with you.ill buy your old bcr if you wanna sell…
You must be logged in to reply to this topic.