No MIDI Output?

Home › Forums › Support › No MIDI Output?

Tagged: 

This topic contains 2 replies, has 2 voices, and was last updated by Avatar of Christian Christian 5 years, 12 months ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • December 27, 2018 at 10:08 pm #6568
    Avatar of Tim Haley
    Tim Haley
    Participant

    I’ve downloaded the new firmware and all went well per the instructions. However, I can’t seem to get any MIDI data output from the Zaquencer. I have a MIDI to USB cable that lights up when data is present. I confirmed that it works both ways with another device. Yet when I connect the Zaquencer, my Mac doesn’t see it and when I start the sequencer, there is no MIDI data output even though the LEDs on the unit behave as expected. Is there a way to reset the hardware? Is there a way to tell if I have a hardware problem? Any advice would be welcome!

    Thank you.

    Tim

    December 27, 2018 at 10:16 pm #6569
    Avatar of Tim Haley
    Tim Haley
    Participant

    Nevermind, I found the problem. I had previously set the track up to DRUM mode. I just went back and reset it to Chord mode and it seems to be working.

    December 29, 2018 at 9:08 am #6575
    Avatar of Christian
    Christian
    Keymaster

    Hi Tim,
    ah good to hear that you found the error.
    I was just thinking up a few things you could try, but even better.

    Cheers,
    Christian

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.