note display

Home › Forums › Support › note display

This topic contains 3 replies, has 2 voices, and was last updated by Avatar of richard richard 3 years, 10 months ago.

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • January 18, 2021 at 5:20 pm #7301
    Avatar of richard
    richard
    Participant

    Sorry but I’m new to the Zaquencer, does anyone know if there’s a way to display the note value on an individual step without turning the encoder? It says some where in the manual (Page 20, 7.6 Note Display) “If the encoder is only being pushed, the LCD will show the actual note value” I don’t seem to be able to get it to do so, any suggestion?
    With Kind regards
    Richard Anderson

    January 18, 2021 at 5:26 pm #7302
    Avatar of richard
    richard
    Participant

    Ok sorry, I understand the “If the encoder is being pushed” bit now, that display the current value of that setting, i.e Note Dispaly.
    It would still be nice to see individual step note values, when its not running.

    January 18, 2021 at 6:18 pm #7305
    Avatar of Christian
    Christian
    Keymaster

    Hi Richard,

    you can preview the value of every encoder by holding “page <” when turning.
    This will not alter the parameter, but display it in the LCD.

    Cheers,
    Christian

    • This reply was modified 3 years, 10 months ago by Avatar of Christian Christian.
    January 20, 2021 at 6:49 pm #7309
    Avatar of richard
    richard
    Participant

    Thank you

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)

You must be logged in to reply to this topic.