Overlay sizing

Home Forums Tips and Tricks Overlay sizing

Tagged: 

This topic contains 3 replies, has 3 voices, and was last updated by Avatar of Eliah Eliah 4 years ago.

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • #5112
    Avatar of Eliah
    Eliah
    Participant

    I printed out the overlay but it turned out too small for the BCR. I had it printed at a print shop, I assume they just printed it straight. Is there something I should change to print proper size?

    #5116
    Avatar of Francisco
    Francisco
    Participant

    I think you should tell them to print without margins (ie. the full size picture). Mine looks nice. Probably not as nice as the sticker but does its job while I save for one :)

    #5117
    Avatar of Christian
    Christian
    Keymaster

    The overlay should be printed at “actual size” or 100%.
    We┬┤ve tested this a couple of times and it always yielded an overlay of the correct size.

    #5122
    Avatar of Eliah
    Eliah
    Participant

    Thank you! I’ll tell the printer to print without margins (I think that might have been the issue as I can’t imagine why they would print at less than 100%) and then test on some cheap plain paper 1st. Unfortunately I traveled out to a printer and paid $12 only to come home and discover it was too small.

Viewing 4 posts - 1 through 4 (of 4 total)

You must be logged in to reply to this topic.