[munkee bParticipant]

Hi Christian,
Sorted! Updated to latest update 1.04 and everything is working perfectly!

Thanks for your ongoing support and a greeat product!

Thanks
Munkee b

[munkee bParticipant]

Hi Christian,

I have been using the TR-8 as the master, which triggers the Zaq fine. I have used the Zaq as the master, which works fine. it is just when I introduce the ERM that things go wrong. Yes, the ERM triggers the TR-8, but not the Zaq, but if I press play on the TR-8 the Zaq works. I have tried every possible Midi configuration I can think of. I have tried to trigger my other units via the ERM individually and directly and they all start stop fine….

I will look at updating the version software.

Appreciate your ongoing support and would appreciate any other options you can think of.

Thanks
Munkee b

[munkee bParticipant]

Hi Cristian,

Thanks for getting back promptly. My Mac is in the repair shop at the moment so unable to run midi Monitor, hence the Analogue set up.

The Zaq is set to external clock. The ERM is connected to USB for power only. All other devices are connected via midi/Din. All the Midi lights on the Zaq blink when I start the TR-8, and on my other connected devices (very odd). I set the output to through on the Zaq and the TR-8 sends Midi and I can hear an audible signal from my Moog Minitaur (plays the midi note information of the TR-8). It just does not want to start/stop…..On a couple of occasions a get a very brief blip from the Zaq, as if it is trying to start, but then it stops. I must admit I have not updated the firmware since I purchased it, but I doubt that this is the issue.

Very confusing?

Many Thanks
Munkee b

[Author]

Posts