Forum Replies Created
-
Posts
-
pls disregard my previous post
I found the latest version. Thanks!how can I download the latest version of zaquencer. I thought it appears under my profile.
Weird it works again. Did you try it in more complex midi connection rings? It seems like as a standalone sequencer it works fine at least just now. When ghost edits did occur I had connected it as a 3rd device in my midi setup and it sequenced 2 sound modules.
Yes. I tried it. It worked fine for 5-10 minutes and then the same did occur. I will try to reinitialize to original Behringer firmware to see whether all knobs are working there.
Hi, I think the unit` strange behavior is more likely that values are decreasing in 1 value, but always end on a minimum value. E.g. i select clock divider value 32 and then it continuously decreased to value 1..
-
This reply was modified 10 years, 1 month ago by Peter.
Hi, I noticed the same issue like other guys described above. For 2 weeks it was fine when I was using it and then suddenly I observed that on each knob the values are decreasing. It is very frustrating since I cannot select the right value. I detected it when I was trying to select a different value on clock divider knob. Later the strange behavior did occur on other knobs too.
-
This reply was modified 10 years, 1 month ago by