Forum Replies Created
-
Posts
-
Hi Zaq , looking forward to dipping my toes into digital waters , being tied so long in the analogue world , it was the knobs that sold me.
Great product and I’m sure Behringer owe you a beer or too—would not have bought it without Zaquencer firmware.
Best wishes
GeoffHi Zaq , got the response code , entered that , “init” came up on the display , then 24 encoders went of like a dog at a fireworks show , it was over quick , display reads 63 ,track 1 is flashing , all encoders are lit up—-I guess its alright.
Turned it off , turned it back on still the same.
Pity I don’t have a midi synth handy to check it out—moogs and arps don’t speak that lingo.
Need to do some shopping.
The Midi Ox config was simply selecting bcr2000 in the output window—I told you I was digitally challenged.
Thanks again for your patience and assistance—-if you need a full restoration on a moog , arp etc , I’m your man.
I assume it has installed OK.
RegardsHi Zaq , it seems I’ve had some luck.
All answers to problems are simple and most are human error.
I needed to configure Midi Ox correctly—lots of trial and error.
It seemed to download OK via usb. On switching off then back on I was presented with the challenge display.
Followed your instructions for authorization , or thought I did , entered the 8 numbers/letters , but nothing happened after that, no “init” in display , no 24 encoders flashing—any ideas?
Thanks for your patience and help.
RegardsHi AB , care to name one.
RegardsHI , first time poster , an old fart and digitally challenged , and I need help installing the firmware.
I’ve tried 3 midi interfaces , from $10 to $180 , all no go.
I’m sure I have configured Midi Ox correctly—-set the buffer to 305 bytes , latency to 150 ms ,have put the bcr in load mode.
Sent sysex and monitered upload , all good , but no download.
Tried the usb method , same deal , all looked good , close but no cigar.
At the moment I have no Zaquencer , all I’ve got is an expensive boat anchor—-wost of all i don’t even have a boat!!!!!!
Little help please.
Regards