Drewzeus

Forum Replies Created

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #6289
    Avatar of Drewzeus
    Drewzeus
    Participant

    Hey Christian,

    The idea that I’m rolling around my head would entail me trying to send a cc to change a relay switch, but to use a value that causes no change. For instance, if a value of 1 is on, 0 is off and 2 is invert, then would a value of 3 be consumed, recognized, and filtered?
    Another idea involves a midi control to change the BPM while the Zaquencer is configured to use an external clock source.

    With this line of thinking, I am trying to find messages that are consumed by the Zaquencer but are passed by other devices in my system (Soundsculpture switchblades, Behringer UMC1820 and FCB1010UnO, etc.) which are devices that are unconcerned with MIDI timing structures.
    I can program a confirmation with a lack of a response in this way. Are there any ideas for messages to send along these lines of thinking?

    I think I may be drifting off of the category a little though. My apologies.

    Thanks,
    Drew

    #6281
    Avatar of Drewzeus
    Drewzeus
    Participant

    Hi Christian,

    I have tried this, but I may not have done it correctly as I don’t think I was in ‘Store’ Menu.
    I was shipped away from my system for work and will not be back until Saturday. I’ll give it another try at that time.

    On the other side, are there any messages I can send that will be recognized, but won’t make any changes?

    Thanks,
    Drew

    #5847
    Avatar of Drewzeus
    Drewzeus
    Participant

    Behringer UMC 1820 worked just fine to install firmware version 1.5 from stock firmware.

Viewing 3 posts - 1 through 3 (of 3 total)